废旧硬质聚氨酯泡沫塑料的木质素改性及再生

采用含有二乙二醇(DEG)和乙醇胺(ETA)的双组分解交联剂降解废旧硬质聚氨酯泡沫塑料(PU硬泡),并利用降解得到的低聚物多元醇与木质素复合制备出性能增强的再生PU硬泡。通过对制备的再生PU硬泡的红外光谱、密度、吸水率、抗压强度、热稳定性、导热系数、热重曲线等进行分析测试,考察m(DEG)∶m(ETA)对再生PU硬泡性能的影响。实验结果表明:m(DEG)∶m(ETA)=1∶3时废旧PU硬泡的降解效果最好;木质素加入量为2.0%(w)时再生PU硬泡的密度低、抗压强度高、保温性能良好,达到国家标准《建筑绝热用硬质聚氨酯泡沫塑料》(GB/T 21558—2008)的品质要求。     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

固相萃取-气质联用法测定固体废物浸出液中的二硝基苯

建立了一种利用固相萃取法对固体废物浸出液(TCLP)中二硝基苯进行萃取,DB-5石英毛细管柱(30 m×0.25 mm×0.25μm)进行分离,质谱检测器检测二硝基苯的方法。方法在0.002 0~0.020 0 mg/L之间线性关系良好,二硝基苯三种同分异构体的检出限均为0.5μg/L,模拟样品加标回收率为93%~96%,RSD≤2%;实际固体废物样品测定的加标回收率为95%~98%。     

Simple Model of Dissolved Oxygen Consumption in a Bay within High Organic Loading: An Applied Remediation Tool

San Vicente Bay is a coastal shallow embayment in Central Chile with multiple uses, one of which is receiving wastewater from industrial fisheries, steel mill effluents, and domestic sewage. A simulation model was developed and applied to dissolved oxygen consumption by organic residues released into this embayment. Three compartments were established as function of: depth, circulation and outfall location. The model compartments had different volumes, and their oxygen saturation value was used as baseline. The parameters: (a) BOD₅ of the industrial and urban effluents, (b) oxygen demand by organic sediments, (c) respiration, (d) photosynthesis and (e) re-aeration were included in the model. Iteration results of the model showed severe alterations in Compartment 1, with a decrease of 65% in the oxygen below saturation. Compartment 2 showed a small decline (10%) and compartment 3 did not show apparent changes in oxygen values. Measures recommended for remediation were to decrease the BOD₅ loading by 30% in the affected sector. Iteration of the model for 200 h following recommendations derived from the preceding results produced an increase in saturation of 60% (5 ml O₂ L⁻¹), which suggested an improvement of the environmental conditions.     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

垃圾焚烧烟气中HCl与消石灰的反应机理研究

测试了两种消石灰与垃圾焚烧烟气中HCl的反应率,得出了消石灰的反应率与反应时间的反应曲线,分析了消石灰与HCl的反应机理及影响消石灰最终反应率的因素。试验结果表明,消石灰与HCl反应初期按灰层扩散控制进行,两种消石灰的最终反应率分别为16％和36％。     

Bhopal disaster—a personal experience

Bhopal Gas Tragedy was the worst industrial accident in the world where several thousand persons lost their lives. It occurred at the Union Carbide plant located inside the city of Bhopal and close to the railway station, at midnight of December 2-3, 1984 due to the leakage of MIC gas which took the local sleeping and floating population unawares.

This paper describes the experience of a transit passenger who reached the Bhopal Railway Station by train at about the same time when the deadly gas leakage occurred.     

北京市发展CNG汽车的条件与前景分析

北京市汽车排放污染物贡献率已达到：HC73.5％，CO63．4％，NOx46％。用CNG代替汽油作汽车燃料，可使CO减少97％、HC减少72％、NOx减少39％、CO2减少24％、SO2减少90％。建立CNG加气站和CNG汽车改装这两个CNG应用关键问题在技术上、经济上都是可行的。北京市CNG燃料来源有保障。北京市车辆都比较适合使用CNG气体燃料。北京有很强的CNG汽车产业科技力量。对北京市当前发展CNG汽车产业提出了一些建议。     

安全评价方法在危险废物处置环境风险评价中的应用探讨

对安全评价方法在危险废物处置建设项目环境风险评价中的运用进行初步探索。主要用"工艺过程风险因素分析表"对工艺过程潜在风险性识别;用蒙德法进行源项分析;用池火灾模型、蒸气云爆炸伤害模型对易燃、易爆物质的火灾、爆炸等重大事故后果进行计算,得出人员的伤亡半径和财产损失半径等参数,以便于判断风险的可接受水平。分析结果表明:采用安全评价方法对危险废物处置建设项目进行环境风险评价是适用的、可行的。     

城市燃气管道事故应急抢修方案的决策分析

通过对近年来的城市燃气管道事故抢险统计数据的分析与研究,管道事故抢险方案的选择存在着很大的主观性和片面性.为了克服应急抢修方案的种种局限,笔者应用模糊综合评判方法建立了城市燃气管道事故应急抢修方案评价选择模型;考虑可靠性、抢修时间、事故损失、抢险费用、社会影响及政治影响等6类影响因素来评判抢修方案的优劣,可以科学合理地选择最佳的管道事故应急抢修方案,达到经济合理、快速可靠的目的;实例验证,评判模型对城市燃气管道事故抢险具有重要的现实意义和参考价值.